- Boat Forum
- etec dead zone between idle and accelleration on 225 hp motor with std binnacle
etec dead zone between idle and accelleration on 225 hp motor with std binnacle
by Paul San Clemente
When I start the motor at idle and move the lever into gear it starts propelling the boat at about 500 rpm's to get it to go faster I must move the throttle about 15 degrees . In this zone the speed stays at idle when I finally get response if it is too much , I muse go back to idle and start all over. this is a pain when trolling for fish.
Click here to post comments
Return to FISHING and BOATS FORUM