power steering problems

by steve
(dana point)

I have a 28 foot maxum. It seems as the power steering system is not working. The actuator and power steering pump where just replaced. The cable seems to move freely with the cable disconnected from the actuator. Is there something I am missing in the install of the pump & actuator?...Adjustment maybe?

steering problem

by Mike
(Grapevine, TX)

7.4 Mercruiser Fuel Injected Bravo 1 outdrive, Wants to go hard left when you give it throttle. Really have to hold tight to the wheel and try to steer right to keep it straight. But if you let off the gas and you have any pressure on the wheel to the right, the wheel will yank right. Very dangerous. I think I have a hydraulic problem. Replaced hydraulic cylinder but no joy.

Steering fluid

by Bob
(Austin)

Can I use auto transmission fluid in Volvo inboard outboard in place of Volvo steering fluid?


NOT ADVISABLE, different viscosity and different properties, get the real stuff

Lund Steering Box Removal

by Mark B
(Canada)

I'm trying to remove the dash from my 2000 Lund 1700 Pro Sport. How do I remove the parts on the steering column/box to allow the steering column to drop back thru the dash?

power steering belt always loosens on 3.0 L gm

power steering belt seems to come loose after ashort period of running.

my power steering is loosing fluid but i can't find the leak

my power steering is loosing fluid but i can't find the leak

1980 charger steering is real hard to turn

Just bought this boat and the steering is scarey hard to turn. It has a 150 merc. Any ideas ?

steering cable issue

by Jason
(Grand Rapids, MI)

I own a 1978 Tiara Sport Salon 25' Flybridge model. My last time on the boat, in October, the steering cable broke. She is powered with an OMC 800 outdrive, and the part number is 979919 on the steering cable. I am having difficulty finding one, and I'm wondering if this can be retrofit with a different brand name. Teleflex seems to be the brand I see most out there. Can anyone help?

Remove Steering Cables

by Tony
(Marshall, TX)

I want to repair my trailer and transom on a 1984 Skeeter Starfire w/150hp Mariner. I have repair manuals for the motor and have purchased DIY manuals as well - but none of them share much information about removing the outboard from the hull (specifically the steering linkage). How does the linkage disconnect from the motor?

play in steering 2007 seaboss w/90 hp merc

by Tom Ure
(Tampa Fl.)

need more input on how to adj/repair play in steering wheel on my boat it's only 3yrs. old with 35hrs on motor.any suggestions from mechs. or boat owners welcome.

Steering actuator

by Andrew
(Canada)

I just took delivery of a new boat with twin Volvo Penta (430 hp) Duo prop stern drives. The boat is equipped with the Volvo Penta Joy stick. At the dock, I pressed the docking button and nothing happens. I get a message on the monitor "low voltage to steering actuator" As well on powering up, the port engine will not go over 3000 rpm. Any thoughts? The boat has brand new batteries, 2 cranking and one house. I believe all wires were connected properly and all breaker fuses are ok. Is there a specific fuse or relay to the steering actuator or the joy stick?

Steering is stiff

by F. Fuller
(California)

I have a 93 bayliner 1950 Cuddy with rack n pinion steering. It is really stiff. I know I need to grease/oil it but where are the parts that need the oil and how do I access them?

steering

by john hart
(lakeside, ca)

I cant turn the steering wheel and the outboard motor will not turn

play in steering 2007 90 hp merc

by Tom
(Tpa., Fl.)

I have 3 maybe 4 inches of play in my steering cable before the motor moves, how can I fix?

Steering problem - 991 Yahama Pro V 150

by Tony
(Indianapolis)

Great sight! I have an older model Cajun fishing boat. It has a 1991 Yahama Pro V 150 on it. The engine runs good but the problem I have is with the steering. As the boat gains speed, the boat wants to dramatically steer right. I have adjusted the motor fin, but it has no effect on it. I have also check the mount on the engine and all seems to be good. As the boat is still, weather in the water or not, the steering is fine. The problem exists and gets worse as the boat gain speed. Is it possible that one of the cables are rusted on the inside? I don't know. Any help would be appreciated

hydrolic steering

by Ron
(Florida)

2000 Sea Ray Sundancer, Steering is exstremly tight, were do I lub it or add hydrolic fluid.

Thank You,
Ron

2003 bayliner 175 steering cable

by T
(TX)

I unplugged the cable from the helm and engine but I am unable to pull cable off the backend. Is there a way to do this?

hard steering with new cables

by ray
(portland tn)

1985 18 ft stratos installed new cables . steers good till in water then steers hard.

steering problems

I have about 3"-4" of play in my steering wheel. I have a 2002 sea ray 300 sundancer. I do not believe this is normal, is there anything I can check before I call a mechanic

power steering

by andres
(casselberry florida)

glastron sx 2004

I have this glastron sx 2004 with a suzuki 90hp very nice boat but the power steering its hard to move, i think i need put some greese but the thing is how can fix my boat if somebody can help me i really appreciate.

Stiff Steering on 1995 Astro 17cc 90hp Outboard

by Brett M.
(Lafayette, LA)

I have a 1995 Mercury outboard that takes 2 hands to steer and is way too tough. I have searched online and see a million different solutions and it's just overwhelming. I have seen everything from replace the cable, putting something called the cable buddy etc etc. can someone please help I can't afford to pay someone to fix it but I'm also not a mechanic.

steering very stiff on inboard motor

by Gina Perugi
(S.C.S, MICHIGAN, USA)

I have a problem with the steering inboard motor. I don't think it's the cables, could it be the hydrolic piston or power steering pump.

cant turn steering wheel

by mike
(florida)

I bought an old bass tracker w/28hp Johnson and after sitting for a couple years can't turn left or right.Will greasing all the fittings help fix the problem? thanks, mike