Mercury Optimax 135 2007

by Alan
(Rapid City, SD)

The engine I am having problems with is a 2007 Merc. Optimax 135. Very low hour engine. Engine starts and runs great. Trim/tilt works fine but the trim/tilt gauge is stuck in the full UP position. The gauge does not move when activating trim/tilt up or down. After a while at a slow speed the constant beep starts and will only go away after cutting power to idle. Acts just like the signal when experiencing cavitation from trimming up too much. Gauge again doesn't move. Any help out there? AK

Click here to post comments

Join in and write your own page! It's easy to do. How? Simply click here to return to Mercury Forum.