bench seat on a 1994 364V Ranger boat

by Larry
(Hereford Az)

I am trying to find out where the screws are that is keeping my bench seat on my 1994 364V Ranger boat from being pulled up. I have looked in the live well and there are no screws leading to the back of the bench seat. Also is there somewhere I could purchase a manual for my boat? Thank you for any assistance

Comments for bench seat on a 1994 364V Ranger boat

Average Rating starstarstarstarstar

Click here to add your own comments

Mar 03, 2010
Bench seat screws
by: JP

I have a '94 392v so if your bench seat is like mine the screws are beind the passenger and driver side under rear seat panel.
The panel hinges between the top of the seat and the back deck. Slide a putty knife between the fabric bead and the fabric edge. Get you fingers in there and work it out a little at a time. you can do this on both sides of each panel. The panel has velcro holding to the molded seat and the bottom edge is hard to get over the back deck so its not easy. But be patient and you will work it out. Once open there will be 3 screws securing the seat to a plate. Once both sides have the screws removed, slide the seat forward a bit and lift out. There are 2 metal tabs in the front that slide into a slot in the molded seat to secure the front.

Dec 04, 2009
Lost in frustration?!
by: Anonymous

I to am looking for manuals or help getting the bench seat out on a ranger 205vs and cant find anything.No factory support, they just want to sell boats.inseam

Click here to add your own comments

Join in and write your own page! It's easy to do. How? Simply click here to return to FISHING and BOATS FORUM.